42
GB
Ignition key switch (3d)
Pos. Function
0
Engine off.
The ignition key can be removed.
I
Headlights on.
The headlights are switched on in this position after the engine has started.
II
Operating position when the engine
is running.
III
Start position for starting the engine.
Release the key as soon as the engine is running. Then it springs back to
operating position II.
Dashboard with and without display
Read this chapter if your lawn tractor has a display (Fig. 4) above the standard dashboard
(Fig. 3).
Function keys and display
Item Designation Function
4 b
The display shows
- Daily operating hours (indicated to one decimal place)
CAUTION - The daily operating hours are indicated
using the decimal system (1.5 h = 1 h 30 min).
or
- Total operating hours (indicated without decimal place).
CAUTION - The total operating hours start counting as
soon as the ignition key is turned to position I.
4 e
To change over the display.
- Total operating hours
- Daily operating hours
- Battery voltage
CAUTION - Counting of the total operating hours
continues if the ignition key is left in the ignition lock in
position “I”.
4 n
Resetting the daily operating hours to “0”.
CAUTION - Only the daily operating hours can be reset
to “0” - not the total operating hours.
To Next Page
Loading...
