ENG 19HOW TO USE THE MACHINE
FITTING THE PROTECTION AT THE EXIT (GRASS-
CATCHER OR STONE-GUARD)
Never use the machine
without having fitted the exit protection!
Lift the removable cover (1) and hook on the
grass-catcher by inserting the two pivots (2)
into the slots on the two supports (3).
If you want to work without using the grass-
catcher, a stone-guard kit (4) is available on
request which is fitted as shown in the figure.
There is a micro-switch
which stops the engine or prevents starting when
the blade is engaged if either the grass-catcher
or stone-guard is not in position. IT IS VERY
DANGEROUS TO TAMPER WITH OR LIMIT THE
EFFECTIVENESS OF THIS DEVICE!
C
HECKING THE SAFETY SYSTEMS
Every time before using, check that the safety systems
are working properly. To do so, simulate the various situations of usage shown in
the table on page 26, making sure that the correct result is achieved for each
situation.
C
HECKING THE BRAKING SYSTEM
Make sure that the machine’s braking capacity is adequate for the conditions of
usage. Avoid starting the machine if you have doubts on the brake efficiency. If
necessary, adjust the brake and if you still have doubts on its efficiency, consult a
Licensed Service Centre.
B
LADE CHECK
Check that the blade is sharpened properly and firmly fixed to the hub. A badly
sharpened blade pulls at the grass and causes the lawn to turn yellow.
!
WARNING!
!
WARNING!
To Next Page
Loading...
