EMAK Oleo-Mac OM 106 - MAINTENANCE AND ADJUSTMENT; 6.1 OVERVIEW OF CHECKS AND MAINTENANCE

52
6
│
MAINTENANCE AND ADJUSTMENT
Properly performed regular maintenance and inspection of the riding mower helps to increase its problem-free operating lifetime.
Worn or damaged parts must be replaced in time. When replacing parts use only original spare parts, using non-original parts
may damage the machine, endanger the health of the driver or other persons and during the warranty period it voids the
warranty. To order spare parts always contact the machine's manufacturer or an authorised service centre.
Incorrectly performed or completely neglected maintenance may lead not only to problems with the operation of the riding mower, but
may also cause injury to its operator.
All safety and protective elements that are removed during maintenance, must always be reinstalled to their correct location and
tested for functionality.
6.1 OVERVIEW OF CHECKS AND MAINTENANCE
INTERVAL ASSEMBLY ACTIVITY
BEFORE
EVERY USE
Engine and transmission Check oil level
6.2.1
6.3.16
Travel drive belt Inspection and adjustment 6.3.12
Brake Inspection of controls 6.2.1
Tyres Inspection of pressure 6.2.1
Cables Inspection of mounting, inspection of quick coupler parts 6.2.1
Bolt connections Inspection, tightening if necessary 6.2.1
Mowing deck Inspection of tension of the cogged blade drive belt 6.3.9
Safety switches and elements Inspection of function 6.2.1
AFTER FIRST
2 HOURS
Engine and transmission Check oil level 6.2.1
AFTER FIRST
5 HOURS
Travel drive belt Inspection and adjustment
4
6.3.12
Mowing deck
Inspection of tension of the cogged blade drive belt
4
6.3.9
Inspection of the correct tension of the mowing deck
drive V-belt
4
6.3.8
AFTER EVERY USE
Mowing deck
Cleaning and washing 6.2.2
Inspection of the correct tension of the mowing deck
drive V-belt
6.3.8
The entire machine Cleaning 6.2.2
Grass catcher Cleaning of the textile sack 6.2.2
Bolt connections Inspection, tightening if necessary 6.2.1
AFTER 25 HOURS
Battery Inspection of electrolyte and cleaning 6.3.1
Bolt connections Inspection, tightening if necessary 6.2.1
Travel drive belt Inspection and adjustment 6.3.12
Front axle and steering Inspection and adjustment of play 6.3.11
Mowing deck
Inspection of play, alignment of shafts, inspection and
sharpening of blades
3
6.3.6
6.3.7
Lubrication Lubrication of parts according to lubrication plan 6.4