What to do if my EMAK Lawn Mower engine won't start?
If the starter motor runs but the engine doesn't start, the battery might be insufficiently charged. Recharge it. Also, check the fuel level in the tank. Open the fuel stopcock if your model has one. Inspect the fuel filter and ensure the spark plug cap is securely fitted, with clean electrodes and the correct gap.
Why does my EMAK Lawn Mower engine shut down while I'm working?
The engine might shut down because a safety device in the electronic circuit board has been activated. Turn the ignition key to the «STOP» position and check that all starting conditions are met.
Why is my EMAK Lawn Mower mowing unevenly?
Uneven mowing and poor grass collection can occur if the cutting-means assembly isn't parallel to the ground, or if the forward speed is too high for the grass height. Check the tire pressure and realign the cutting-means assembly. Reduce forward speed and/or raise the cutting-means assembly. Ensure the grass is dry and empty the collector channel if it's blocked.
What to do if my EMAK Lawn Mower is vibrating unusually?
Unusual vibrations while working may be due to the cutting-means assembly being full of grass, unbalanced or loose cutting means, or loose bolts and screws. Clean the cutting-means assembly and check and tighten all engine and frame bolts.
Why is my EMAK Lawn Mower starting difficult or running erratically?
Difficult starting or erratic engine performance may be due to faulty carburetion. Try cleaning or replacing the air filter, emptying the fuel tank and refilling it with fresh fuel, and checking and replacing the fuel filter if needed.
Why EMAK Lawn Mower has weak engine performance during cutting?
Weak engine performance during cutting can happen if the forward speed is too high relative to the cutting height. Reduce the forward speed and/or raise the cutting height.
What to do if EMAK Lawn Mower machine starts to vibrate abnormally?
If the machine starts to vibrate abnormally, it might have damaged or loose parts. Stop the machine, disconnect the spark plug cable, and inspect for damage. Check for and tighten any loose parts.
What to do if the EMAK Lawn Mower does not move when the drive pedal is pressed?
If, with the engine running, the machine does not move when the drive pedal is pressed (hydrostatic transmission models), the release lever might be in position «B». Move it to position «A».
What to do if my EMAK Lawn Mower's ignition light doesn't turn on?
If the indicator light or dashboard remains off when the ignition key is turned to «ON», the safety device of the electronic circuit board may have cut in. This could be due to a badly connected or flat battery, crossed battery terminals, a blown fuse, or a wet circuit board. Turn the ignition key to the «STOP» position and check the connections, recharge the battery, replace the fuse (10 A), and dry the circuit board using warm air.
What to do if my EMAK Lawn Mower light flashes but the starter motor doesn't run?
If the light flashes but the starter motor doesn't run when the ignition key is turned to «START», it could be that the starting conditions have not been met. Check that all starting conditions are met.
General| Brand | EMAK |
|---|---|
| Model | KJK 92H Series |
| Category | Lawn Mower |
| Language | English |
To Next Page