Hydrostatic transmission:
4.31
4.32
speed.
-
ing that increasing the pressure on the
– The pedal automatically goes into neutral
Reverse must be en-
gaged when the machine has stopped.
NOTE If the drive pedal is used, wheth-
er forwards or for reverse, when the parking
brake (4.4) is engaged, the engine stops.
4.33
label:
«A
«» = Transmission disengaged: this
machine by hand,
turned off.
To avoid damaging the
transmission unit, this operation must be car-
ried out only when the engine has stopped
with the pedal (4.32) at position «N”.
5.1
If the machine is likely to
be used mostly on sloping ground (never
steeper than 10°), fit counterweights (sup-
plied on request (see 8.1) beneath the cross-
member of the front wheels. These improve
stability at the front and reduce the chances
of tipping over.
All the references relating to
the positions of controls are those described in
chapter 4.
5.2
a) To start the engine, it is necessary that:
– the operator is seated.
b
-
-
5.3
5.3.1
-
5.3.2
-
-
-
5.3.3
NOTE The type of oil and fuel to use is given
in the engine manual.
-
ing to the instructions in the engine manual, this
To Next Page
Loading...
