-
lights (8).
-
6.3.5
-
-
A blown fuse must always be
replaced by one of the same type and ampere
rating, and never with one of another rating.
6.3.6
Always wear strong protec-
tive gloves to handle the cutting means.
Always replace damaged or
bent cutting means; never attempt to repair
them! ALWAYS USE ORIGINAL CUTTING
MEANS!
Only cutting means bearing the code indicated
in the table on page ii must be used on this ma-
chine.
-
-
Cutting means should be
replaced in pairs, especially when there are
marked differences in wear.
6.3
6.3.1
The cutting-means assembly should be prop-
-
6.3.2
NOTE If you have to replace one or both rear
wheels, make sure that any differences in their
external diameter does not exceed 8-10 mm; on
the contrary, you must adjust the cutting-means
assembly alignment to prevent uneven mowing.
Before remounting the wheel,
apply grease to the axle. Put the snap ring (1)
and shoulder washer (2) back in place.
6.3.3
The tyres are “Tubeless” and must be replaced
6.3.4
-
laterally.
To Next Page
Loading...
