Emax Interceptor RaceView Manual

1. Normal display
All LEDs on the VTX are normally off until the
button is pressed. To check band and channel
status click the button once quickly, and LED
starts to indicate frequency band and frequency
channel. First indicate the frequency band and
then indicate the frequency channel. After all 2
rounds of LED display cycles, all LED will be off.
2. Menu Entry / Exit
(1)Press the button and hold for 5s to enter the
menu. After entering the menu, BAND LED
lights up.
(2)Press the button and hold for 5s again to save
parameters and exit the menu. After saving
and exiting the menu, all LED goes out.
3. Band and Channel parameter change
After entering menu, short click button to switch
frequency group band(b)/frequency channel (C),
and the LED of the corresponding menu is lit.
4.Enter/Exit Parameters
(1) After choosing menu, press the button and hold
for 2s to enter parameter option. And the
corresponding LED flash.
Button Menu Diagram
CE and FCC unlicensed user chart
VTX Channel Settings with the Button
7

Emax Interceptor RaceView Specifications

General

Brand	Emax
Model	Interceptor RaceView
Category	Drones
Language	English