Emax Tinyhawk II Manual

This is a 2.4 GHz radio, The radio is powered with
3×AA batteries.
Power on and off by toggle the remote control
switch button. The power indicator light will turn
red when on. The red light flashes quickly when
the remote control battery is low.
1.Take out the USB cable, and connect the cable
to USB port on the interceptor .
2.Connect the other end of the line to the computer
USB port. While charging, the LED will light up;
when fully charged, the LED will light off.the
charging current is 500mA.
3.Disconnect the cable from the interceptor.
The radio comes already bound to interceptor. If
binding is necessary follow these steps:
1. Make sure the radio and the interceptor are
powered off.
2. Power on the radio, the power indicator light
will turn on. Press the bind button after power
on the radio. Then the radio enter bind mode.
The red light will slow flash after the radio enter
in bind mode.
3. Power on the interceptor, and ensure it is close
to the radio, the red light on the radio will steady
light when binding has been completed.
4. Repower the interceptor.
Battery
Charge battery of Interceptor
Operation
Power
Binding
3

Emax Tinyhawk II Specifications

General

Brand	Emax
Model	Tinyhawk II
Category	Drones
Language	English