EMC-PARTNER IMU4000 - Page 5

IMU4000
5/104
5.5.1 Test set up EFT 50
5.5.2 ESD test set up 51
5.5.3 Test set up SURGE 52
5.5.4 Test set-up for table top equipment 54
5.6 Practical testing sequence 55
6 TESTING WITH THE IMU4000 57
6.1 Operation of the tester via touch screen monitor 57
6.1.1 General information about the touch screen monitor 57
6.1.2 Selecting the parameter – Example CWG 57
6.2 The general menu 61
6.2.1 General menu “Setups” 61
6.2.2 General menu “Setup Linker” 61
6.2.3 General menu “Protocols” 61
6.2.4 General menu “Settings” 62
6.2.5 General menu “System” 63
6.2.6 General menu “Power” 63
6.2.7 EUT - Power and EUT - Control 63
6.2.8 General menu “Update” 64
6.3 EMC test operation „RUN Mode“ 64
6.3.1 Example CWG operation 65
6.3.2 Web Server 65
7 MAINTENANCE AND SERVICING 67
7.1 Maintenance 67
7.2 Cleaning front and rearplate 67
7.3 Verification versus Calibration 67
7.3.1 Verification Example IEC 61000-4-4 Ed.2 67
7.3.2 Calibration Example IEC 61000-4-4 Ed.2 67
7.4 Verification of the IMU4000 by the user 67
7.4.1 EFT 67
7.4.2 ESD 68
7.4.3 SURGE 68
7.4.4 Interruption 68
7.4.5 Variation 68
7.5 Calibration of the IMU4000 by EMC PARTNER AG 69
7.6 Service of SPD Surge Protective device 69
8 WHAT MUST BE DONE FOLLOWING FAILED OPERATION 71
8.1 Service; Repairs 71
8.1.1 Service Flowchart of IMU4000 System: 72
8.1.2 Data Transfer via UBS Stick 72