EasyManua.ls Logo

EMC VNX5300 - 2 U, 25 (2.5-inch) DAE Front View

EMC VNX5300
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EMC® VNX5300™ Hardware Information Guide
66
EMC® VNX5300™ Hardware Information Guide
2U, 25 (2.5-inch) DAE front view
On the front, viewing from left to right, the Block and File VNX5300 2U, 25 (2.5-inch)
DAE includes the following hardware components:
2.5-inch 6-Gb/s SAS, 6-Gb/s NL-SAS, or Flash disk drives (hot-swappable)
18
Status LEDs
Figure 63 shows the location of these components.
Note: In a Block and File VNX5300 platform, when using the 2U, 25 (2.5-inch) disk drive
carrier, the maximum amount of disk drives is 125 (includes DPE and expansion DAEs).
Figure 63 2U, 25 (2.5-inch) DAE (front view)
Table 41 describes the 2U, 25 (2.5-inch) DAE and disk drive status LEDs.
18. You can add or remove a disk drive while the DAE is powered up, but you should exercise
special care when removing modules while they are in use. Drive modules are extremely
sensitive electronic components.
1 2.5-inch 6-Gb/s SAS or 6-Gb/s NL-SAS drives 4 Disk drive fault LED (amber)
2 DAE fault LED (amber) 5 Disk drive status/activity (blue)
3 DAE power status LED (blue)
1
4
VNX-000276
5
2 3
Table 41 2U, 25 (2.5-inch) DAE and disk drive status LEDs
LED Color State Description
DAE fault (location 2) Amber On Fault has occurred
DAE power (location 3) Blue On Powering and powered up
Off Powered down

Other manuals for EMC VNX5300

Related product manuals