I/O modules
VNX5700 Hardware Information Guide 61
Two-port 10-Gb/s optical or active Twinax I/O module
The two-port 10-Gb/s optical or active Twinax
19
I/O module comes with two optical ports,
one power/fault LED, and a link and activity LED for each port (Figure 53). The optical ports
on this I/O module can interface at speeds of 10 Gb/s. The two-port 10-Gb/s optical I/O
module uses the SFP+ transceiver module, hence the required SFP+ transceiver module
uses a different part number (for part number label location, see the
VNX5700 Parts
Location Guide
).
Figure 53 Two-port 10-Gb/s optical I/O module
19. The two-port 10-Gb/s I/O module can also use active twinaxial (Twinax) cables. Twinax is a type of
cable similar to coax, but with two inner conductors instead of one. These cables will be supplied
in lieu of the SFP+ transceiver module when so ordered.
1Push button latch handle 4SFP+ link LED (right)
2 Power/fault LED 5 SFP+ activity LED (left)
3 SFP+ (optical) port (two)
1
0
1
2
3
4
5
CNS-001756
To Next Page
Loading...
