Emerson ACTURA Flex 48330 - 5.7.2 Battery Selection Settings

Chapter 5 Operating SCU 55
ACTURA Flex 48330 Power System User Manual
Battery Setting

Batt. Selection
LVD Setting
Charge

Battery Setting


Batt. Test
Temp Comp
What follows is the description of the parameter functions and values by dividing
them into 5 small categories and 5 big categories.
5.7.2 Batt. Selection
1. The first page of the Batt. Selection is shown below:
Mode: Manual
Batt String: 1
Capacity: 300Ah
Batt Name: 1#

Use “
” or “” to select the page and the parameter to be set, and “” or “” to
select the proper value for the parameter. Press “ENT” to confirm.
After setting the “Battery Type”, the following prompt will appear, asking you to
name a certain type of battery for the sake of identifying them:
Battery Name:

Batt1
To name a rectifier, you can use “
” or “” to change the number, and “” or “”
to move the cursor left or right. Press “ENT” to confirm afterwards.
2. If setting parameter “System Type” does not require setting the battery shunt
coefficient, the second page of the basic battery settings is as follows:
Batt Shunt1:

Y
Batt Shunt2:
Y