CI-ControlWave EFM Installation & Operation / 2-9
- There should be clearance for the optional Solar Panel (if required) (the Solar Panel
may be mounted to the same 2” pipe that secures the unit.
- Power wiring should not be installed until the unit has been mounted and grounded at
a designated work site.
- I/O wiring, external power wiring, RTD cabling, local comm. port, antenna cable, and
network (RS-232 and RS-485) comm. port cabling enter the bottom of the unit though
conduit or special function fittings.
Figure 2-4 - Side View of ControlWave EFM Mounted to a 2” Pipe
To Next Page
Loading...
