Product Service Centers
America
Emerson Process Management
835 Innovation Drive
Knoxville, TN 37932
Tel: 865−675−2110
Fax: 865−218−1401
Brazil
Emerson Process Management Ltd.
Av Hollingsworth 325
Sorocaba, SP
BRAZIL 18087−000
Phone: 55 15 2383788
Fax: 55 15 22823300
Europe, Middle East, Africa
Emerson Process Management
div. ESAD
MHM Repair Center
Piestanska 1202/44
915 28 Nove Mesto nad Vahom
Slowakia
Tel: +421/32/7700 538
Fax: +421/32/7700 884
Asia
Emerson Process Management / Asia
Pacific Private Ltd.
3904 Room Central Plaza
18 Harbour Road Wan−Chai
Hong Kong
Tel: 852−2802−9223
Fax: 852−2802−8227
Incoming goods inspection
Check the content of the shipment to ensure that it is
complete; visibly inspect the goods to determine if the
device may possibly have been damaged during
transport. The following parts are included in the scope
of delivery and must be contained in the shipment.
1. A6151
2. Product information
If the contents are incomplete, or if any defects are
observed, a complaint must be filed with the carrier
immediately. Moreover, the responsible Emerson sales
organization must be informed to enable repair or
replacement of the device. Repairs or calibration that
may be required, are only possible at the Emerson
factory.
In this case, a non−detachable tag with customer name,
defect observed and version of the A6910 configuration
software must be attached to the device.
Repair and maintenance
During operation, monitors do not require any mainte-
nance.
Repair or calibration of monitors is only possible at
Emerson.
i
The additional PCB (controller board)
is calibrated with the main board and
must not be replaced.
If work with the opened device on−site is
unavoidable, this should only be performed by a
specialist who is familiar with the associated
hazards.
STOP
Capacitors in the device can still be
energized, even if the device has
been disconnected from all power
sources.
To Next Page
Loading...
