Quick Installation Guide Mounting the Actuator to the Valve
QIG 8000-81-003 Ed 01 February 2020
14
DPI models only!
Mounting the Actuator to the Valve - DPI models only
14. Dismount the DPI connector housing
from the DPI socket by loosening the
four screws (a).
15. Check signals from the DPI according to
‘Test of the DPI’ on page 15 (DPI-E) or
page 17 (DPI-C) depending on model.
16. Vessel installations only! Connect the
wires from the DPI connector housing
to the DPI socket according to the corre-
sponding DPI Data Sheet (ref. page 2 in
th
is instruction) or the Project Specifica-
tion Wiring Diagrams.
17. Mount the DPI connector housing and
tighten the four screws (a).
18. Vessel installations only!
– Mount the hydraulic pipes to the control block.
– De-air the hydraulic pipes.
To Next Page
Loading...
