10
SETTING THE CLOCK
The time of day appears on the display when the system is in the Standby mode or
when the AUX function is selected.
While the time is showing on the display:
1.) Press the MEMORY/CLOCK-ADJ
button on the front panel or the remote
control once. The Hour digits begin to
flash.
2.) Press the R-SKIP or F-SKIP buttons to adjust the
display to the correct hour. Make sure to set 'AM' or 'PM'
correctly.
3.) Press the MEMORY/CLOCK-ADJ button again. The Hour
digits stop flashing and the Minute digits begin to flash.
4.) Press the R-SKIP or F-SKIP buttons to adjust the display to the correct
minute.
5.) Press the MEMORY/CLOCK-ADJ button once more. The
Minute digits stop flashing and the clock begins to run.
IMPORTANT: After pressing the MEMORY button you must press the R-SKIP
or F-SKIP buttons to adjust the display within 10 seconds while the digits are
flashing. If the display stops flashing press the MEMORY button again and then
press the R-SKIP or F-SKIP buttons to adjust the display.
NOTE: If the system is disconnected from AC power for more than 2 days, it may
be necessary to reset the clock when the power is restored.
ES11_ib022503.p65 25/2/2003, 16:0510
To Next Page
Loading...
Need help?
General
