EasyManua.ls Logo

Emerson Fisher EHD - Parts List

Emerson Fisher EHD
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Instruction Manual
D100394X012
EH (1-1/2x1 through 8x6)
July 2017
29
Parts List
Note
Contact your Emerson sales office
or Local Business Partner for Part
Ordering information.
Bonnet Assembly (figure 16)
Key Description
 1 Bonnet
 If you need a bonnet as a replacement part,
  order by valve size and stem diameter,
  serial number, and desired material.
 2 Baffle, for use with extension bonnet only
 3 Packing Flange
 4 Packing Flange Stud (2 req'd)
 5 Packing Flange Nut (2 req'd)
 6* Packing Set or Arrangement
 7* Packing Ring, low chloride graphite
 8 Packing Spring, 316 stainless steel
 8 Lantern Ring, 316 stainless steel
10 Special Washer, 316 stainless steel
11* Packing Box Ring, 316 stainless steel
12* Upper Wiper, felt
13 Packing Follower, 316 stainless steel
14 Pipe Plug 
14 Lubricator
14 Lubricator/Isolating Valve
15 Yoke Locknut 
25 Actuator Mounting Stud (8 req'd)
26 Hex Nut (8 req'd)
35 Retaining Ring, for use with extension bonnet only
Valve Body (figures 18‐21) 
 1 Valve Body, order by valve size, serial
 number, and desired material
 2* Cage
 3* Valve Plug
 4* Valve Plug Stem
 5* Pin
 6* Seat Ring
 7* Seat Ring Retainer
Key Description
 8* Piston Ring or Seal Ring
 9* Backup Ring
10* Retaining Ring
10* Retaining Ring (for EHT valve body only)
11* Cage Gasket (2 req'd)
12* Seat Ring O‐Ring or Gasket
13 Bonnet Stud (8 req'd)
14 Hex Nut (8 req'd)
15 Flow Arrow 
16 Drive Screw (4 req'd)
24 Anti‐seize Lubricant 
25 Seat Ring Retainer Tool (see figure 9)
 416 stainless steel
26* O‐Ring (for valve with Cavitrol III
 trim only), ethylene/propylene
27 Nameplate
28 Nameplate Wire
29 Bonnet Washer 
29 Flat Washer (8 req'd)
30* Piston Ring (for EHT with Level D Whisper Trim III cage only)
33 Belleville Washer, N07718 (8 req'd)
63* Anti‐Extrusion Ring
C‐seal Trim (figure 10)
2* Cage
3* Valve Plug/Retainer
4* Valve Plug Stem, S20910
6* Seat Ring
8* Piston Ring, graphite (2 req'd)
64* C‐seal, N07718
TSO Trim (figure 7)
2* Cage
4* Seat Ring
5* Plug/Stem Assembly
8* Seal Ring
63* Anti‐Extrusion Ring
9* Back Up Ring
10* Retaining Ring
*Recommended spare parts

Related product manuals