7-1 A7420INT
HOW TO INITIALIZE THE LCD TV/DVD
To put the program back at the factory-default, initialize the LCD TV/DVD as the following procedure.
< DVD Section >
1. Press [1], [2], [3], [4], and [DISPLAY] buttons on the
remote control unit in that order.
Fig. g appears on the screen.
2. Press [CLEAR] button on the remote control unit.
Fig. h appears on the screen.
When “OK” appears on the screen, the factory
default will be set.
3. To exit this mode, press [CH. o / p] button to go to
TV mode, or press [POWER] button to turn the
power off.
< LCD TV Section >
1. Turn the power on. (Use main power on the TV
unit.)
2. To enter the service mode, press the service
button on the service remote control unit. (Refer to
page 6-1.)
- To cancel the service mode, press [POWER]
button on the remote control.
3. To initialize the LCD television, press [DISPLAY]
button on the remote control unit.
4. Confirm "FF" indication on the upper right of the
screen.
MODEL : *******
Version
: *.**
Region
: *
EXIT: SELECTEEPROM CLEAR : CLEAR
Fig. g
"
*******
" differs depending on the models.
MODEL : *******
Version
: *.**
Region
: *
EEPROM CLEAR : OK
EXIT: SELECTEEPROM CLEAR : CLEAR
"
*******
" differs depending on the models.
Fig. h
To Next Page
Loading...
