Emerson LD200EM8 - Marker Setup

36
EN
O
PERATING DVD
Marker Setup
Marker Setup
This feature allows you to assign a speci c point on a disc to be called back
later.
To set a marker
1
During playback, press [MODE] repeatedly until
“ ”/“ ” appears.
e.g.) DVD
_ _ /12 (SEARCH)
2
Use [Cursor
K
/
L
] repeatedly until maker search menu
appears.
e.g.) DVD
or
3
Use [Cursor s / B] to select an available marker within
60 seconds.
e.g.) DVD
or
4
When the playback reaches the point at which you
want to set a marker, press [ENTER].
• Marker is now set.
e.g.) DVD
5
Press [RETURN] to exit.
To return to the marker later
1
To select a desired marker, repeat steps 1-3 in
“To set a marker“.
e.g.) DVD
or
2
Press [ENTER] at the desired marker to start playback
from the specific point which you set.
e.g.) DVD
Note:
• Maker Search menu will disappear in about 60 seconds when
there is no input.
• You can mark up to 10 points.
• To clear a marker, select the marker to be cleared, and then
press [CLEAR].
• Ejecting the disc or turning off the power will erase all
markers.
• Selecting “
” at step 3 in the section “To set a marker”
or “To return to the marker later” will also erase all
markers.