Emerson PACSystems RX3i - Agency Certifications

Battery & Energy Pack Manual Chapter 3
GFK-2741J Oct 2019
Energy Packs 29
Status Information
The Energy Pack provides the following status information to the Controller, which it uses
to generate fault and status bit indications. For Controller fault and status bit details, refer
to the Controller user manual.
Charging
The Energy Pack is charging; not yet fully charged.
Fault
A hardware fault exists in the Energy Pack.
Low capacitance
The Energy Pack is near its end of life and should be replaced.
Charged
The Energy Pack is fully charged and is ready to support CPU operation.
Energy Pack LEDs
Details on the LED operation for this Energy Pack are listed in LED Indications.
3.2.12 Agency Certifications
The following table lists the standards to which the Energy Pack has been certified.
Description
Agency Standard or
Marking
Comments
N.A. Safety for
Information
Technology Equipment
Certification by Underwriter's Laboratories
to UL 60950-1and CSA 60950-1
N.A. Safety for
Industrial Control
Equipment
Certification by Underwriter's Laboratories
to UL 508 and CSA C22.2 No 142 - M1987
Electromagnetic
Compatibility Directive
European EMC
Self-Declaration in accordance with
European Directives; Refer to Technical
Support at
https://www.emerson.com/Industrial-
Automation-Controls/support for EC
Declaration of Conformity
Note: The agency approvals listed above and on the Declaration of Conformities are believed to
be accurate; however, a product’s agency approvals should be verified by the marking on
the unit itself.