EasyManua.ls Logo

Emerson PeC C100 - 3 Installation; Important Recommendations; Controller Installation

Emerson PeC C100
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16 AGL_Sol_PEC_01_E_Rev01
3 Installation
3.1 Important recommendations
The controllers must not be installed in environments where the following situations are present:
temperature and humidity outside the range stipulated in the data plate; frequent and sudden
changes in temperature and/or humidity;
direct sunlight and weathering in general;
high mechanical stress (vibrations and/or knocks);
sulphur and ammonia gas, smoke and salt spray that can cause corrosion and/or oxidation;
dust (no direct airstream over electronics Pollution degree 2 must be fulfilled);
devices that generate magnetic interference.
3.2 Controller installation
Position the controller inside the electrical panel, paying attention to the following:
distance between the device and the electrical power components;
distance between the device and the power cables;
sufficient passage for the cooling air.
NOTE: Ensure compliance with the laws and regulations applicable in the country where the
controller is installed.
NOTE: The controller must always be protected in such a manner that it is accessible solely to
authorised personnel. In case of malfunctions, always contact the relative distributor for the
device to be repaired.

Related product manuals