Emerson PNC001-A Series User Manual

PACSystems™ RX3i and RSTi-EP CPU Reference Manual Section 1
GFK-2222AK October 2019
Introduction 4
Rev
Date
Description
U
Nov-
2014
▪ New Section, A-3.6 for EGD Sweep Impact for RX3i CPE302/CPE305/CPE310 and
RSTi-EP CPE100/CPE115 Embedded Ethernet Interface.
T
Oct-
2014
▪ Support for OPC UA using embedded Ethernet port in CPE305/CPE310 with CPU
firmware 8.20.
▪ Support for Ethernet Global Data (EGD Class 1) using embedded Ethernet port in
CPE305/CPE310 with CPU firmware 8.30 Sweep impact of EGD on Embedded
Ethernet interface. Direct replacement for S90-30 IC693CPU374.
▪ New communications capabilities provided by:
o IC695PNS001 – PROFINET Scanner Module
o IC695GCG001 – Genius Communications Gateway via PROFINET
o IC695EDS001 – Ethernet based DNP3 Outstation
S
July-
2013
▪ Support for Modbus/TCP Server, SRTP channels and Modbus/TCP client channels on
RX3i CPE305/CPE310 embedded Ethernet interface – Section 2: & Section 5:
▪ Support for Access Control List – Section 3:
▪ Modbus TCP/IP mapping for CPE305/CPE310 – Section 3:0
▪ Enhanced Security Passwords and OEM Protection – Section 4:
▪ Serial I/O protocol enhancements (Data Set Ready, Ring Indicator, and Data Carrier
Detect) – Section 6:
▪ Diagnostics for PROFINET alarms and PROFINET network faults, including
#PNIO_ALARM, SA0030 – refer to PACSystems RX7i and RX3i CPU Programmer’s
Reference Manual, GFK-2950 Section 3 & Section 9.
▪ Instruction executions times measured for RX3i CPU320/CRU320 – Appendix A:
▪ Sweep impact times for new modules: IC694MDL758, IC694APU300-CA and later,
IC695PNS001, IC694ALG442, IC694ALG220, IC694MDL645 and IC694MDL740–
Appendix A:

Emerson PNC001-A Series Specifications

General

Brand	Emerson
Model	PNC001-A Series
Category	Controller
Language	English