ROC364 Instruction Manual
B-3 Local Display Panel Rev Jun/05
Use the following steps to install the Local Display Panel.
1. Inspect the kit and verify that there are no missing parts.
2. Remove the cutout cover from the enclosure door.
3. Place two small drops of Room Temperature Vulcanizing (RTV) sealant on the LCD sub-
assembly to hold the window in place while installing the panel. Refer to Figure B-3.
TAB UP
RTV
LCD SUB-ASSEMBLY
WINDOW
RTV
Figure B-3. LCD Sub-Assembly
4. Remove the protective paper from the window and place the window in the cavity.
5. Place a small bead of RTV (approximately 1/16" wide) onto the gasket surface. Align the gasket
holes to the door studs with the RTV facing the door and press into place. Refer to Figure B-4.
INSIDE VIEW OF DOOR
GASKET
HOLES
RTV
GASKET
DOOR
STUDS
Figure B-4. LCD Inside View of Door
6. Place a small bead of RTV (approximately 1/16" wide) around the edge of the window. Refer
to Figure B-5.
To Next Page
Loading...
