Need help?Do you have a question about the Emerson Rosemount 3051S ERS and is the answer not in the manual?
General| Model | 3051S ERS |
|---|---|
| Category | Accessories |
| Operating Temperature | -40 to 85°C (-40 to 185°F) |
| Transmitter Compatibility | Rosemount 3051S |
| Communication Protocol | HART |
| Housing Material | Stainless Steel |
| Compatibility | Rosemount 3051S |
| Enclosure Rating | NEMA 4X |
| Product Type | Electronic Remote Sensor (ERS) System |
Introduction to the manual, covering its usage and product recycling guidelines.
Details the step-by-step process for installing the ERS System.
Guides on identifying the Primary (PHI) and Secondary (PLO) sensors.
Instructions for physically mounting the PHI and PLO sensors.
Details how to make process connections using flanges and adapters.
Explains how to use the security and alarm switches on the primary transmitter.
Details wiring connections for typical systems and those with remote displays.
Procedures for proper loop wiring grounding and transmitter case grounding.
Recommends verifying and configuring essential items for ERS System functionality.
How to assign ERS System parameters to HART variables for primary and secondary outputs.
How to configure lower and upper range values for the analog output.
Options for configuring failure mode alarm and saturation levels.
How to change the PHI and PLO module assignments for correct DP calculation.
How to configure the ERS System to output HART messages for parameter deviations.
Outlines the tasks involved in calibrating the Rosemount ERS System.
Lists the tasks required for calibrating the Rosemount ERS System.
Instructions for individually calibrating the PHI and PLO pressure sensors.
How to adjust the calculated DP measurement of the ERS System.
How to adjust the 4-20 mA output to match control system standards.
Lists possible diagnostic alerts from a HART host and recommended actions.
To Next Page