9 Product certifications
Rev 9.17
9.1 European directive information
The EU Declaration of Conformity for all applicable European directives for
this product can be found on EU Declaration of Conformity. The most current
revision is available at Emerson.com/Rosemount.
9.2 Safety Instrumented Systems (SIS)
SIL 3 Capable: IEC 61508 certified for use in safety instrumented systems up to
SIL 3 (Minimum requirement of single use (1oo1) for SIL 2 and redundant use
(1oo2) for SIL 3).
9.3 Ordinary location certification
As standard, the transmitter has been examined and tested to determine that
the design meets the basic electrical, mechanical, and fire protection
requirements by a nationally recognized test laboratory (NRTL) as accredited
by the Federal Occupational Safety and Health Administration (OSHA).
9.4 Installing equipment in North America
The US National Electrical Code
®
(NEC) and the Canadian Electrical Code (CEC)
permit the use of Division marked equipment in Zones and Zone marked
equipment in Divisions. The markings must be suitable for the area
classification, gas, and temperature class. This information is clearly defined in
the respective codes.
9.5
USA
9.5.1 E5 Explosionproof (XP), Dust-Ignitionproof (DIP)
Certificate
FM16US0444X
Standards
FM Class 3600 – 2011; FM Class 3610 – 2010; FM Class 3611 –
2004; FM Class 3615 – 2006; FM Class 3810 – 2005; ANSI/ISA
60079-0 – 2013; ANSI/ISA 60079-11 – 2012; ANSI/NEMA
®
250
– 2003;
Markings
XP CL I, DIV 1, GP B, C, D; DIP CLII/III, DIV 1, GP E, F, G; T4; -50 °C
≤ Ta ≤ 60 °C / 70 °C; Type 4X
Special Conditions for Safe Use (X):
1. WARNING – Potential Electrostatic Charging Hazard – The enclosure
contains non-metallic material. To prevent the risk for electrostatic
sparking the plastic surface should only be cleaned with a damp cloth.
February 2019 Quick Start Guide
Quick Start Guide 29
To Next Page
Loading...
