March 2016
4
Quick Start Guide
1.2 Mechanical considerations
The mounting site for the Rosemount 8750W should provide enough room for
secure mounting, easy access to conduit entries, full opening of the transmitter
covers, and easy readability of the LOI screen if equipped.
For remote field mount transmitter installations, a mounting bracket is provided
for use on a 2-in. pipe or a flat surface (see Figure 1).
Rotate integral mount transmitter housing
The transmitter housing can be rotated on the sensor in 90° increments by
removing the four mounting screws on the bottom of the housing. Do not rotate
the housing more than 180° in any one direction. Prior to tightening, be sure the
mating surfaces are clean, the O-ring is seated in the groove, and there is no gap
between the housing and the sensor.
NOTICE
If the transmitter is mounted separately from the sensor, it may not be subject to limitations that
might apply to the sensor.
To Next Page
Loading...
