4. Note to which COM the USB Serial Port is connected (this will vary among
computers).
5. From the Comport dropdown, select the relevant COM port.
6. Click the OK button.
Once the port is set, a message displays that the Modbus Manager must be
restarted.
2.8 Connecting the device
The device must be connected to power and the RS485 should be connected to the
terminals according to the following table:
Function Wire color Terminal
RS485 (+) Red 13
RS485 (-) Black 14
Note
The detector address set by the factory is ‘1’. When locating the detector address, only
one detector should be connected.
Initial setup Reference Manual
June 2021 00809-1500-4975
12 Emerson.com
To Next Page
Loading...
