Emerson Roxar - Tools and Equipment; Consumables for Operation

3.2 Tools and equipment
Table 3-1:
Description Size Quantity Comments
Spanner ⅛ in 1 Required during field operation for the
mechanical plug (hexagon)
Adjustable spanner Small & medium 2 Required during field operation for
adjusting the device (coupon holder,
probe or injection nut), pipe plug, and
coupon nut
Flathead
screwdriver
1 Required for assembly coupons
Hex key kit 2.5 mm to 10 mm Kit Required for the assembly plug and
devices, assembly tool, and service valve
Hex key bits and
compatible ratchet
6 mm to 10 mm Kit Required for the assembly tool and
service valve
Hex socket 19 mm 1 Required for the assembly tool and
service valve
Torque wrench 25 N m to 160 N m 1 Required for the assembly tool and
service valve
Brass or plastic
hammer
1 Required during field operation
Retainer ring pliers 1 Required for assembly tool
Pin hook wrench 6 mm tap 1 Mechanical covers and retriever union
thread adapter
Multipurpose
lubrication
1 Multipurpose or marine lubricant
Grease or lubricant 1 High-temperature grease or lubricant
Note
Additional equipment may be required depending on facility requirements or the type of
fluid in process (for example, a container to discharge media, bucket, rags, and absorbent
pads).
3.3 Consumables for operation
This section describes key consumables available to perform retrieval operations.
Additional consumables may be required, depending on the device being used (for
example, coupons and insulators, probe and probe packing, o-rings for injection nuts, o-
rings for pressure proof covers). Check the user manual of the particular device for further
information.
For information on the consumables for maintenance, refer to Maintenance.
Preparation
User Manual
June 2020 ROX000295904
22 www.Emerson.com/Roxar