Unidrive M / HS Frame 7 to 10 Power Installation Guide 81
Issue Number: 5
Safety information Product information Mechanical installation
Electrical installation
Technical data UL listing information
Refer to section 5.1.24 Electromagnetic compatibility (EMC) on page 110 for further information on
compliance with EMC standards and definitions of environments.
Detailed instructions and EMC information are given in the Unidrive M / Unidrive HS EMC Data
Sheet which is available from the supplier of the drive.
4.11.6 Compliance with generic emission standards
Use the recommended filter and shielded motor cable. Observe the layout rules given in Figure 4-19.
Ensure the AC supply and ground cables are at least 100 mm from the power module and motor
cable.
Figure 4-19 Supply and ground cable clearance
³100mm (4in)
³100mm
(4in)
³100mm (4in)
9E
Unidrive M frame7 to 10 Power Installation Guide issue5.book Page 81 Tuesday, May 24, 2016 11:52 AM
To Next Page
Loading...
