Emerson UNIDRIVE M600 - Page 48

48 SI-Ethernet User Guide
Issue: 1
Controls whether the module will use VLAN tagging.
When used in conjunction with Drive VLAN ID (S.02.031) network traffic from the
interface will be tagged with the chosen VLAN identifier.
When default value for Drive VLAN ID (S.02.031) is set, enabling this parameter will add
VLAN prioritisation to all packets, helping to ensure real-time packets are not delayed by
those of lower priority. If disabled, prioritization will use the Diffserv field in IP traffic only,
meaning non-IP traffic can still affect real-time IP traffic.
Specifies the VLAN ID that the interface will be a member of. Any packets entering the
switch without this VLAN ID will not be handled.
Enable the Non cyclic data transfer.
The value in this parameter points to the base address of a group of seven sequential
parameters which are used for handling non cyclic data by user programs.
S.02.030 VLAN Enable
Minimum 0 Maximum 1
Default 0 Units
Type 1 Bit User Save Update Rate Read on module reset
Display Format None Decimal Places 0
Coding RW
S.02.031 Drive VLAN ID
Minimum 0 Maximum 255
Default 0 Units
Type 8 Bit User Save Update Rate
Read on module reset
and VLAN_ENABLE
Display Format None Decimal Places 0
Coding RW, BU
S.02.035 Non cyclic enable
Minimum 0 Maximum 1
Default 0 Units
Type 1 Bit User Save Update Rate Background
Display Format None Decimal Places 0
Coding RW
S.02.036 Non cyclic base parameter
Minimum
0
(Display: 0.00.000)
Maximum
59999
(Display: 0.59.999)
Default
0
(Display: 0.00.000)
Units
Type 16 Bit User Save Update Rate Background
Display Format Slot Menu Param Decimal Places 0
Coding RW, BU