Emerson UNIDRIVE M600 - Page 55

SI-Ethernet User Guide 55
Issue: 1
Safety
information
Introduction
Mechanical
installation
Electrical
installation
Getting started Parameters
Key features
and Protocols
PC Applications Security Diagnostics
Glossary of
terms
Index
This parameter is used to set the number of contiguous parameters for the Tx1 link.
This parameter specifies the type of transmission for the Tx1 link.
This parameter specifies the IP address of the destination device for the Tx1 link. If Tx1
Link Transmission Type (S.10.014) is set to either broadcast or one of the multicast
settings this parameter will display the appropriate address.
S.10.013 Tx1 Parameter Count
Minimum 0 Maximum 10
Default 0 Units
Type 8 Bit User Save Update Rate Read on reset
Display Format None Decimal Places 0
Coding RW, BU
S.10.014 Tx1 Link Transmission Type
Minimum 0 Maximum 5
Default 0 Units
Type 8 Bit User Save Update Rate Read on reset
Display Format None Decimal Places 0
Coding RW, TE, BU
Value Text Description
0 Unicast Link is unicast to the IP address specified
1 Broadcast Link is broadcast (255.255.255.255)
2 Multicast1 Link is multicast to the IP address (239.255.0.1)
3 Multicast2 Link is multicast to the IP address (239.255.0.2)
4 Multicast3 Link is multicast to the IP address (239.255.0.3)
5 Multicast4 Link is multicast to the IP address (239.255.0.4)
S.10.015 Tx1 Destination Address
Minimum
0
(Display:0.0.0.0)
Maximum
4294967295
(Display: 255.255.255.255)
Default
0
(Display:0.0.0.0)
Units
Type 32 Bit User Save Update Rate Read on reset
Display Format IP Address Decimal Places 0
Coding RW, BU
This parameter value is not locked and may be changed by the user, if this value is
changed to any of the multicast addresses (Multicast1, Multicast2, Multicast3 or
Multicast4) or the broadcast address then Tx1 Link Transmission Type (S.10.014) will
indicate the appropriate setting.
NOTE