Unidrive M700/M701 / Unidrive HS70/HS71 Control Getting Started Guide 45
Issue Number: 2
Safety information Introduction Control connections Getting started
Basic parameters
(Menu 0)
Running the motor
Further information
The data for the selected motor is displayed on the 'Motor Setup' screen. Click 'Send to drive' to set the
associated parameters.
It is possible to set motor parameters for motor 2, by selecting the 'Motor 2' tab and following the same procedure.
Unidrive M700_M701 Getting Started Guide English iss7.book Page 45 Friday, December 12, 2014 1:14 PM
To Next Page
Loading...
