Note: If the WPS button is used, the SSID and network key are the same as used on
your wireless router. Some WPS routers will change their original SSID to another
SSID if WPS is used. In this installation guide, the SSID of the wireless router is
‘Eminent’.
4.0 Connecting a wireless WPS adapter to the
EM4595
1. Press the WPS button on the EM4595 for about 3 seconds.
2. Now press the WPS button on your wireless adapter.
3. The connection between the wireless WPS adapter and EM4595 will be
established. Depending on the Windows version you are using, you should see a
connected icon in the taskbar.
Note: Some wireless WPS adapters require the use of the supplied software to create
a WPS connection. Refer to the manual of your wireless WPS adapter for more
information.
5.0 Configuring the EM4595 manually
It is possible to configure the repeater manually instead of using the WPS button.
5.1 Manual configuration
1. Connect the EM4595 to a wall outlet (preferably close to the modem/router).
2. Wait for the signal indicator to turn green. This will take approximately 1 minute.
3. Connect to the EM4595 via Wi-Fi SSID: Eminent_repeater, or use the Ethernet
cable to connect to the EM4595 directly.
4. Open your internet browser and type http://192.168.10.1 in your internet browser
and then hit Enter.
5. The login screen will appear. Enter the Username: “admin” and Password:
“admin”, then click “Log in” to login.
To Next Page
Loading...
