40
Solo, Sento, Sento PRO V 1.1
unit.
7) Assembly of the seat unit fabric
ERGO
See point 1) Montera Seat unit Assembly of the
seat unit
FLAT
1. Place the seat unit fabric in the seat
unit. Thread the shoulder straps
through the fabric.
2. Thread the crotch strap through the
seat fabric.
3. Thread the waist straps through the
seat unit fabric.
4. Fasten all of the press studs on the seat
unit.
5. There are a total of 13 press studs. 5
press studs on each side and 3 on the
back.
6. Attach the crotch strap by positioning
it around the bumper bar and secure it
by fastening the press stud.
7 Attach the hood into the frame
8 Attach the hood in place using the
velcro strips attached to the seat unit
fabric.
WARNING
• Never use the pram without making
sure the seat unit fabric is correctly
assembled on the frame rst.
• The hood should always be
assembled when the stroller is in use.
8) Insect Net (delivery with chassis)
ERGO & FLAT
1.Attach the Insect net using the zipper
on the hood. Pull the elasticated band
of the insect net completely over the
footrest.
2. Use the press stud to secure the
elasticated band of the insect net onto
the seat unit. Repeat on the other side.
FLAT
3. Storage pocket for the Insect Net.
9) Assembly of the apron (accessories)
1. Pull the apron over the footrest.
2. Fasten the apron with the press studs
on the inside of the hood and on the
seat frame.
3. Open the zip in the middle of the
apron when taking your child in or out
of the pram.
IMPORTANT! The hood cannot be
folded down when the apron is attached
to the hood.
10) Raincover (accessories)
1. Assemble the rain cover by placing it
over the hood and the carrycot or the
seat unit.
2. The rain cover has a large window at
the top opening that you can open and
close with the Velcro fasteners.
3. Make sure that the side ventilation
windows are always open and free
so that ventilation is ensured. Always
use rain protection when it is raining
or snowing. If the stroller is wet, try to
dry it rst before using the rain cover.
Let the rain cover dry properly before
putting it back in its pocket.
5-punktsselen
(ERGO & FLAT)
1) 5-point harness - Buckle the Child
1. Place the 5 harness straps in front of
the child so that the child is not sitting
on them.
2. Assemble the left shoulder and waist
straps by sliding the upper left buckle
into the lower left buckle until it clicks
into place.
3. Assemble the right shoulder and hip
straps by sliding the upper right buckle
into the lower right buckle until it clicks
into place.
4. Click the right buckle over the left
buckle until they are held together as
a unit. It is very important that they sit
together properly and that they cannot
To Next Page
Loading...
