EMMO E-mini B - Assembly Instructions: Seat Post and Pedals; Seat Post Adjustment; Pedal Installation; Seat Post Height Warning

7
ASSEMBLYINSTRUCTIONS
ForSeatPostandPedals
Pull the seat clamp handle away from the seat post and slide the seat up
or down to adjust the height. Move the clamp handle inward toward the
seat post so that the seat post can be held securely by the clamp. Make sure the seat is
clamped properly so that you can’t twist it out of alignment.
If necessary, tighten the clamp by twisting the clamp handle clockwise while in the
unclamped position. Then, fold the handle in toward the seat post. This should
require a fair amount of force to ensure the seat post is held tight. If necessary, the
clamp can be further tightened with a 5 mm allen wrench while in the clamped
position.

WARNING:Makesuretheseatisnotsetwiththeverticalmaximumheight
marksabovetheclamp.
Using the 15 mm wrench to attach and
tighten the pedals. PLEASE NOTE – The
pedals are marked “L” for Left and “R” for
Right. The left pedal is attached by turning it
counterclockwise and the right pedal is
tightened by turning it clockwise.
Make sure the pedals are properly
attached to the crank arms to prevent
stripping.
TORQUESPECIFICATIONS