EMP OP80 User Manual (English)

Other manuals for EMP OP80

Installation And Operation Manual53 pages

Questions and Answers:

A
Amber SwansonAug 4, 2025
Why is my EMP Water Pump not running at the commanded speed?
- R
  Raymond LeeAug 4, 2025
  The EMP Water Pump may not run at the commanded speed due to the system design. A high downstream circuit flow restriction or a low fluid operating temperature (increased fluid viscosity) can cause the pump to reach its electrical current limit, which will reduce its speed to prevent excessive heat buildup in the controller. Also, using heavier weight oil may be the cause. For pumps on CAN, the controller will provide a status reason why the motor is not at commanded speed.
L
Lori ThomasAug 9, 2025
Why is the flow rate low in my EMP OP80 Water Pump?
- A
  Adrienne JohnsonAug 9, 2025
  A low flow rate in your EMP Water Pump can be caused by: * A clogged suction screen/strainer. * An inlet circuit leak. * Incompatible fluid. * Worn or damaged pumping gear. * Low supply voltage.
S
Stephanie HamiltonAug 14, 2025
What to do if my EMP Water Pump will not run?
- C
  Curtis GrahamAug 14, 2025
  If your EMP Water Pump isn't running, several factors could be at play. Start by checking the supply voltage and electrical connections. A blown fuse could also be the culprit, so replace it if necessary. Additionally, inspect the ignition switch and repair if needed. Finally, clear any debris from the pumping gear, as this might cause it to seize.
L
Lawrence RodriguezAug 18, 2025
Why is my EMP OP80 not priming?
- M
  marie59Aug 18, 2025
  If your EMP Water Pump isn't priming, several issues could be the cause. Start by checking for a clogged suction screen/strainer and clear it if necessary. Also, inspect the inlet circuit for leaks and repair them. Ensure the outlet circuit isn't blocked. Check the fluid level and replenish if it's low. Verify you're using a compatible fluid. Lastly, the pumping gear might be worn or damaged, requiring replacement.
R
Robert HudsonAug 23, 2025
What to do if my EMP Water Pump has a low flow rate?
- E
  erinsmithAug 25, 2025
  If your EMP Water Pump has a low flow rate, there are several possible causes. Check for a clogged suction screen/strainer and clear it. Inspect the inlet circuit for leaks and repair them. Ensure you are using compatible fluid. The pumping gear might be worn or damaged, consider replacing it. Also, verify that the supply voltage is correct.
R
Rachel LindseyAug 29, 2025
Why is my EMP OP80 not running at commanded speed?
- X
  xlewisAug 29, 2025
  The EMP Water Pump might not run at the commanded speed due to several reasons. It may be normal operation depending on the system design, so monitor for expected performance. A high downstream circuit flow restriction or low fluid operating temperature (increased fluid viscosity) can cause the pump to reach its electrical current limit, rolling back its speed. Also, using heavier weight oil can affect the pump speed, so use the recommended oil weight.