5. Installation instructions
5. Installation instructions
Preparing the range hood:
1. Open the electrical knockout that is best for your wiring.
2. Fix the shutter to the range hood’s vent; prevent the
leakage of oil by taping the connection with aluminum
metal adhesive tape, or duct tape.
3. Attach the ruber support to the back of the range hood.
4. Unscrew and remove the range hood’s bottom cover.
Installation:
1. Pass the wiring through the electrical knockout hole in
the range hood.
2. Put the range hood onto the bottom of the cabinet. Make
sure the rear side is close to the wall, and the hood is equally
spaced on each side and that the top of the range hood is
attached to the cabinet. On each side of the range hood, use
2pcs screws to fix the body to the cabinet.
3. Connect the ground wire from power source to the green
ground wire from the range hood. Make the electrical
connection by fastening the white power line to the white
wire then the black power wire to the black wire.
To Next Page
Loading...
Need help?
General
