8
WARNING: All burner caps can’t be dislocated installation, otherwise it will lead to flash back on the
upper aluminum seats and cause the upper aluminum seats to melt and deform, see below figures for
correctly placing the burner caps
Figure 11
Re-ignition:
If the flame is out for certain reasons, the safety device will cut off the gas power automatically. Turn the
switch to " largest flame " position, then ignite again, you should wait for 30 seconds when you do that;
Due to the air in the tong, there may be unsmooth ignition, revolve the switch to " largest flame "
position and ignite again.
Maintenance and Cleaning
Before any maintenance or cleaning can be carried out, you must DISCONNECT the gas cooktop from
the electricity supply.
The gas cooktop is best cleaned while it is still warm; as spillage can be removed more easily than if it is
left to cool.
Control Panel
Sign ● = gas valve is shut off
Sign =largest flame
Sign =smallest flame
Sign = electric discharge for ignition
The Burners
The burner caps and crowns can be removed for cleaning. Wash the burner caps and crowns using hot
soapy water, and remove marks with a mild paste cleaner. A well moistened soap impregnated steel
To Next Page
Loading...
Need help?
General
