5
WWW.EMPIREPAINTBALL.COM
3. BATTERY REPLACEMENT
The MINI requires a single 9-volt battery as the electronic power source. The
use of long life batteries is recommended. The 9-volt battery is located in the
front fore-grip in front of the trigger guard. The battery is accessed through
the removable left side plate on the front fore-grip.
Confirm that the marker is Off. Remove the screw at the bottom that secures
the left side plate in the front fore–grip. If there is already a battery in the
fore-grip, gently disconnect the battery from the battery harness, and then
connect a fresh 9-Volt battery to the harness. Carefully re-insert battery and
harness back into the battery compartment with the harness pointed down
towards the bottom of the grip. Make sure that there are no abrupt kinks and
the wires are comfortably placed, do not force them into place. Then re-install
the fore-grip side plate and screw.
Notes:
- Some rechargeable batteries are too large for the MINI battery compartment. If they don’t fit,
please don’t force them as this may damage the MINI.
- The stock circuit board does not keep user defined settings. You must change the battery
quickly to keep your settings. If the battery is not changed quickly the Circuit board will go back
to the factory default settings.
EMPIRE MINI SPECIFICATIONS
Model- Empire Mini
Barrel- 12" Ported
Caliber- .68
Action- Semi Auto, PSP Ramping, and NXL Full Auto
Air Source- Compressed Air
Battery- One 9 Volt
Cycle Rate- 20 BPS
Main Body Material- Aluminum
Accuracy Range- 150+ ft.
Weight– 1.99 lbs.
INCLUDED WITH YOUR MINI
-12" Barrel (.691 bore)
-Allen Keys
-Spare Parts
-Barrel Sleeve
-One 9 Volt Battery (installed)
To Next Page
Loading...
