Empisal 760 - Setting Up Your Machine; Position of Thread Stand; Cotton Holders; Spool Caps

- 7 -
SETTING UP YOUR MACHINE
Set your Overlock machine on a sturdy flat
surface.
[ THE POSITION OF THREAD STAND ]
Pull up thread stand to its highest point before
threading.
Turn the thread stand so the thread guides
come right above the spool pins.
[ COTTON HOLDERS ]
Both industrial cones and domestic type thread
spools can be used on this machine.
For large diameter industrial cones use the
cone holders with the large end at the top.
For small diameter cones. useUse the same
cone holders with the small end at the top.
[ SPOOL CAPS ]
When using domestic type thread spools,
remove the spool holders and place spool
caps over the thread spools.
Normal
Positioning catches
Spool holder
Domestic type
thread spool
Spool cap
Notch