Here is the appearance of the Output screen when Channel A has previously
been set to Interferential 2-pole (IFT2) in the Setup screen and Channel B
has been set to Russian stimulation (see next page) –
With Channels A and B selected at the bottom left of the display turning up
the rotary control will start both channels running together.
Touching either the ‘A’ or ‘B’ button again would de-select it and allow
individual control of the still-selected channel.
The status bars to the right of each channel strip give a moving indication of
any frequency sweep or Burst/Surge function in real time.
As also in the Setup screen, pressing the ‘Stop’ button will cause the
treatment to stop with the output gradually fading to zero over five seconds.
To Next Page
Loading...
