Interrupted Galvanic Set-up
‘Form’: Three different pulse shapes are available: Rectangular, Triangular
and Trapezoidal. A full description of these waveforms is available in the
technical specification section of this manual.
‘Width’: The pulse width may be set from 1ms to 1s for all waveforms with
additional narrower pulses for rectangular only.
‘Rate’: Pulse rates of 2, 5, 10, 20 and 30 per minute are available.
‘Polarity’: Positive going, negative going or auto-reverse polarities are
available (auto-reverse occurs half way through the selected treatment time).
When running, the output state is represented by a graphic in the lower
centre of the ‘Setup’ screen or to the right of the channel strip in the ‘Output’
screen if selected.
To Next Page
Loading...
