Enable SDM Mode
Method #1: Use the SDM navigation keys. Pressing these keys will automatically enable SDM mode.
Example: Select SDM #2
Navigating to SDM #0 will disable SDM mode.
ABS
SDM MODE
Example: Select SDM #5
ABS
SDM MODE
Method #2. Direct SDM selection
The values in the axis will reflect the current
offset-from zero for the selected datum.
Above is only an example.
Disable SDM Mode
The SDM mode is automatically disabled if SDM #0 is selected.
However it is more common to simply re-press the [SDM] key, e.g.
SDM MODE
ABS
- 20 -
To Next Page
Loading...