EMS FirePoint 5000 - Page 15

EMS 5000 FIREPOINT
©2015 EMS Security Group Ltd. All rights reserved. TSD234 Iss 3 25/06/15 AJM
15
31 Press the “” button and the screen will display:
32 Press the “YES” key and the screen will display:
33 The collector should be set to “ENABLED”, press the
“YES” key to change its status. Once set to “ENABLED”
press the “NO” key and the screen will display:
34 Press the “NO” key and the screen will display:
35 Press the “” button until the screen displays:
36 Press the “YES” key and the screen will display:
37 Press the “YES” key and the screen will display:
38 Enter “00” followed by the “YES” key unless the NUA is
already set to 00. In which case press the “NO” key.
The screen will display:
39 Press the “” button until the screen displays:
40 Press the “YES” key and the screen will display:
41 The Routing should be set to “ENABLED”. If already
set, press the “NO” key. (If “DISABLED” press the
“YES” Key followed by the “NO” key. The screen
should now display:
Collector: ENABLED
Push Yes to change
Push No to escape
Yes= Select Time
| Logging |
>Remote Rxers <
| Ext. Comms |
Yes= Select Time
| Checksum Data |
> Network Router <
| Radio LAN |
Yes= Select Time
|* NETWORK ROUTER*|
> Setup local NUA <
| View network NUA|
Yes= Select Time
Local NUA : 00
Input Local NUA
Yes= Finish Time
|* NETWORK ROUTER*|
> Setup local NUA <
| View network NUA|
Yes= Select Time
| Network Name |
> Control Routing <
| Send Test |
Yes= Select Time
Routing : DISABLED
Push YES to change
Push NO to escape
Yes/No Time
| Network Name |
> Control Routing <
| Send Test |
Yes= Select Time
| Network Router |
> Radio LAN <
| Fire DB |
Yes= Select Time
| Enable Receiver |
> Enable Collector <
| Monitor Traffic |
Yes= Select Time