8.55 Fault : RI:
Radio signal levels can vary due to the surrounding local environment. The following
screen shows that the controller is receiving unknown radio signals above an acceptable
level: -
The Fault RI represents that the panel is receiving Radio Interference.
8.6 Fault : OL:
This fault shows that a controller is currently Off Line on either a Hardwired or radio
networked system. This indicates the Control Panel is no longer communicating with the
Network System. If this has taken place the following fault screen will be shown:-
01 FAULT TOT 01
CONTROL PANEL
FAULT : RI 12:00
01 FAULT TOT 01
CONTROL PANEL
FAULT :OL 12:00
To Next Page
Loading...
