EMtronics EMAFDD9LAQ - Special Cooking Functions; Match Cook and Smart Finish Modes; Pre-Heat and Dehydrate Functions

8
Match Cook
As an option If you are intending to use both zones (both trays) to cook with
identical time and temperature, (usually if cooking the same food type in both
sides), simply push the “Match Cook” button instead of the zone 1 and 2
buttons described in section 2 above. Now any pre-set cooking modes and any
edits to time or temperature will be duplicated in both cooking zones (both sides)
saving time setting them individually.
Smart Finish
If you are intending to use both zones (both trays) to cook with dierent cooking
times (usually if cooking dierent food types in each side). Smart Finish will
automatically delay the start of the shortest cycle so that both zones finish at the
same time.
To use Smart Finish press the “Smart Finish” button first just after switching the
unit on, it will flash to show it is active, then proceed to set the zone 1 and zone 2
in the same way as described in section 2 above.
Pre-Heat/Manual
The Pre-Heat button is simply an extra cooking pre-set mode and can be used
in the same way as any of the pre-set modes (food icons) as described in section 2
above. The Pre-Heat pre-set mode sets the time to 3 minutes and the temperature
to 180°C. As with the other pre-set modes this can also be edited and used as a
Manual setup mode for time and temperature. To Do this, Select the cooking zone
(left or right tray) by pressing button 1 or 2 . Select the Pre-Heat/Manual
button , you can now freely edit both cooking time and temperature. Both
temperature and cooking time are alternated between constantly on each display
to show the current settings.
Dehydrate
Dehydrating food is a preservation method used to extend the shelf-life of
your food by removing its water content. It is also one of the oldest and most
widespread food preservation techniques.
Dehydrate is one of the 8 preset cooking modes included on this air-fryer and can
be selected and carried out by the method shown on the previous page “Using
the Appliance”. It can also be set to run in both cooking trays at the same time if
required.
Please note: As the temperature for dehydrating is much lower than normal
cooking modes it is best not to run the dehydrate mode while cooking at
high temperatures in the other compartment as cross overheat can aect the
dehydrating action.