6
Using the Appliance
1. Power on
When plugging the unit into a wall outlet there will be a beep sound and the
power button will illuminate RED.
Now press the power button and the unit control panel will light up ready for
use.
2. Setting zone, cooking time and temperature:
Select the cooking zone (left or right tray) by pressing button 1 (left side) or
2 (right side).
Then press one of the 11 pre-set cooking modes (food icons) which will input
both the time and temperature automatically. At this stage you can freely edit
both cooking time and temperature if you wish by using Time and
Temperature buttons. Both temperature and cooking time are alternated
between constantly on each display to show the current settings.
Note: If the zone buttons ( 1 or 2) stop flashing, setting mode has timed out (10
seconds max) press zone 1 or 2 again to continue the setting function if needed.
Now if required, select the other cooking zone by pushing button 1 for left tray or
2 for right tray and repeat as above to set for the food being cooked in that zone.
If only using one zone (one cooking tray side) this stage can be skipped.
Press the Start/Pause button to begin the cooking cycle.
When either side reaches a time of “00” a cooling cycle starts for 60 seconds and
the display will remain at “00”, after which beeps will sound and the display will
show “---” indicating the cooking cycle is over.
Match cook
As an option If you are intending to use both zones (both trays) to cook with
identical time and temperature, (usually if cooking the same food type in both
sides), simply push the “Match Cook” button instead of the zone 1
and 2 buttons described in section 2 above. Now any pre-set cooking modes
and any edits to time or temperature will be duplicated in both cooking zones
(both sides) saving time setting them individually.
To Next Page
Loading...
