7
Smart Finish
If you are intending to use both zones (both trays) to cook with dierent cooking
times (usually if cooking dierent food types in each side). Smart Finish will
automatically delay the start of the shortest cycle so that both zones finish at the
same time.
To use smart Finish press the Smart Finish button first just after switching
the unit on, it will flash to show it is active, then proceed to set the zone 1 and
zone 2 in the same way as described in section 2 above.
Pre-Heat/Manual
The Pre-Heat button is simply an extra cooking pre-set mode and can be used
in the same way as any of the pre-set modes (food icons) as described in section 2
above. The Pre-Heat pre-set mode sets the time to 3 minutes and the temperature
to 180°C. As with the other pre-set modes this can also be edited and used as a
Manual setup mode for time and temperature. To Do this, Select the cooking zone
(left or right tray) by pressing button 1 or 2 . Select the Pre-Heat/Manual
button , you can now freely edit both cooking time and temperature. Both
temperature and cooking time are alternated between constantly on each display
to show the current settings.
To Next Page
Loading...
