To Next PageTo Next Page
Need help?Do you have a question about the Encore 2000 series and is the answer not in the manual?
General| Brand | Encore |
|---|---|
| Model | 2000 series |
| Category | Power Tool |
| Language | English |
Pneumatic clipping tool with green housing and clip magazine.
Pneumatic clipping tool with black housing and clip magazine.
Always wear safety glasses during operation, maintenance, or repair.
Avoid the blade and anvil area when operating or connecting air supply.
Disconnect air for clearing jams, maintenance, repairs, or when tool is not in use.
Never point the tool toward yourself or anyone else.
Cross-reference of parts specific to different tool models.
Initial setup and connection steps for the tool.
Routine maintenance procedures to ensure optimal tool performance.
Step-by-step guide on how to use the tool for fastening.
Instructions on how to load clips into the tool's magazine.
Procedure for replacing the tool's blade.
Procedure for replacing the tool's anvil.
Steps to replace the pusher spring in the tool.
Lists clip part numbers and specifications for strip collation.
Lists compatible Hartco tool models for each clip.
Lists compatible Eclipser tool models for each clip.
Description of Encore Eclipser tool variants.
Description of Hartco "E" Series clincher tool variants.
Description of Hartco Classic "A" Series clincher tool variants.
Description of Hartco Classic "B" Series clincher tool variants.
Description of Hartco Classic "C" Series clincher tool variants.
Clip compatibility for tools using strip collation.
Description of the continuous coil clipping system accessory.
Description of the adjustable height rotating table accessory.
Feature of Encore Eclipser and Hartco "E" Series tools.
Description of the hanger assembly accessory.
