HYDROMASSAGE JETS
LARGE HYDROMASSAGE Jets - This jet provides a unique, pulsating
massage. The water flow is adjustable in that it can be turned from low
to high (by rotating the jet faceplate ¼ turn).
MIDSIZE DIRECTIONAL JET - These jets allow you to redirect the
jet stream by changing the position of the nozzle. The water flow is
adjustable in that it can be turned from low to high (by rotating the jet
faceplate ¼ turn)
MIDSIZE ROTATIONAL JET - These jets provide a rotating massage
pattern. The water flow is adjustable in that it can be turned from low to
high (by rotating the jet faceplate ¼ turn)
Mini JET - These jets deliver a direct, more focused massage. The
water flow is adjustable in that it can be turned from low to high (by
rotating the jet faceplate ¼ turn)
WATERFALL VALVE
Your fitness system is equipped with a waterfall feature.
It is activated by turning on the hydromassage jets
(either low or high speed). The flow is regulated by
turning the waterfall valve on the inside wall of the
fitness system.
AIR CONTROLS
Your fitness system is equipped with two air valves. The
air valves will add or remove air to the hydromassage jet
system. Rotate valve to see which hydromassage jets are
affected.
SWIM MACHINE-HYDRAULIC
SWIM MACHINE OPERATION - Two remote controls have been
provided with your system and have
been packaged in the owner's packet
inside the equipment compartment
labeled Swim Current.
The swim machine is turned on
through the use of the remote control, which
also adjusts the speed of the current faster or
slower. When changing speed, you must press
and hold the buttons on the remote, then wait
a few seconds for the current to adjust. Upon initial start-up you will
find that the unit has been set to its lowest speed; which is a barely
perceptible current. You will need to press and HOLD the FASTER
button to increase the speed. Our standard pool’s top speed is roughly
equivalent to a 1:08 100 yard pace (1:14/100 meters) a speed for expert
swimmers only. Set the water speed at a comfortable level for your
needs. Remotes are waterproof but can not be submerged.
IMPORTANT: Starting up the swim machine will automatically turn OFF
the hydromassage jet system if ON, once swim machine is turned OFF
the hydormassage jet system will turn back ON. To stop swimming,
simply press the on/off button on the remote. If left running, the power
unit will turn off automatically after thirty minutes and can be restarted
by pressing the on/off button again. Once you have found an optimal
speed for yourself, you may leave the system at that setting. The
controller for the swim machine is designed with a “ramp-up” feature
which forces the swim machine to start slowly, but will increase to the
last setting at which someone swam.
When you are first learning to swim in the swim current, it is often useful
to allow yourself to drift back to the rear of the pool. Let your feet rest
on the rear seat and then swim forward into position. By starting from
the back, you can get a feel for just how much room you have. When
swimming, center your outstretched arm about one foot from the front grill
.
TREADMILL-HYDRAULIC (OPTIONAL)
TREADMILL OPERATION - Two remote controls have been provided
with your system and have been
packaged in the owner's packet inside the
equipment compartment. These remotes
are identical to the swim machine remotes
but are labeled Treadmill.
Upon initial start-up you will find that unit
has been set to its lowest speed. You will
need to press and HOLD the FASTER
button to increase the speed.
The treadmill is turned on through the use of a remote control, which
also adjusts the speed of the treadmill faster or slower. When changing
speed, you must press and hold the buttons on the remote, then wait a
few seconds for the treadmill to adjust. Set the speed at a comfortable
level for your needs.
Remotes are waterproof but can not be submerged.
To turn off the treadmill, simply press the on/off button on the remote.
If left running, the power unit will turn off automatically after thirty
minutes and can be restarted by pressing the on/off button again. The
treadmill will always default to the slowest speed when turned on.
When you are first learning to use the treadmill in conjunction with the
swim machine, it is best to start at the lowest speeds for both the swim
machine and treadmill. The added resistance the swim machine offers
may allow for a slower treadmill speed then initially thought.
Page 8
Getting Started
To Next Page
Loading...
Need help?
General
